A few weeks ago I typed up a post about cleaning up the frame of my truck and am posting a quick update. I took off the front skid plate and proceeded to alternate between working on the front and rear ends of the frame. I spent some more time chemically dissolving the rubberized goop previously applied to the frame, used a lot of wire wheels and flap discs, and spent so much time cleaning all to spend just a small fraction of the total time actually laying down any paint. In an endeavor such as the one I’m am working on the preparation work is what is the most important. Here are the photos of the forward end (before):
I only took a few photos of the rear:
I’ll post up some more progress photos, a few opinion pieces, and another soldering video soon!
Oh boy, are we in for a good post today folks. Tonight’s post is about the laborious task of removing the rubberized undercoating that the previous owner of my truck applied to the frame and lower portions of the body and bed. I am not a fan of rubberized undercoating as it can make a lot of electrical plugs or bolts difficult to remove, lowers the ability to easily inspect some parts, and cracks over time which allows water to get under it but not easily evaporate. I long ago began the project of removing all of this gunk from my truck and it has been slow going and I still have much left to do. Attempting to use any type of wire wheel, grinding disc, flap disc is ineffective at removing these types of coating as the removal media is rapidly clogged. The use of a chemical means of dissolving the rubberized coating (I just recently noticed that the methylene chloride formula is no longer available in California) is necessitated by this problem and is very miserable and time-consuming.
Here’s a quick video for anyone who is thinking about using rubberized undercoating on their on vehicle:
Here are some of the photos of the work I’ve been doing on the truck most recently:
I had a little mishap as I was removing some rust from the rear axle…
While I really do need to finish this project I probably should have thought a little harder about the variable-gauge wire wheel I was using next to the wheel speed sensor cabling. It would have been so easy to unplug but I decided to test fate instead. I am fairly certain that no harm was done to the sensor but I bought that as well; hopefully I can just return it.
This photo is unrelated to the post, but do you like my custom exhaust mod?